exclusive ! ! Last configuration change at 21:23:40 UTC Thu Sep 3 2015 ! version 15.5 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname iosv-1 ! boot-start-marker boot-end-marker ! ! vrf definition Mgmt-intf ! address-family ipv4 exit-address-family ! address-family ipv6 exit-address-family ! enable password cisco ! no aaa new-model ethernet lmi ce ! ! ! mmi polling-interval 60 no mmi auto-configure no mmi pvc mmi snmp-timeout 180 ! ! ! ! ! ! ! ! ! ! ! no ip domain lookup ip cef ipv6 unicast-routing ipv6 cef ! multilink bundle-name authenticated ! ! ! ! ! redundancy ! no cdp run ! ! ! ! ! ! ! ! ! ! ! ! ! ! interface Loopback0 description Loopback ip address 192.168.0.1 255.255.255.255 ! interface GigabitEthernet0/0 description OOB Management vrf forwarding Mgmt-intf ip address 10.255.0.116 255.255.0.0 duplex full speed auto media-type rj45 ! interface GigabitEthernet0/1 description to iosvl2-3 ip address 10.0.0.1 255.255.0.0 ip nat inside ip virtual-reassembly in ip ospf cost 1 duplex full speed auto media-type rj45 ! interface GigabitEthernet0/2 description to flat-1 ip address 172.16.1.89 255.255.255.0 ip nat outside ip virtual-reassembly in duplex full speed auto media-type rj45 ! router ospf 1 passive-interface Loopback0 network 10.0.0.0 0.0.255.255 area 0 network 192.168.0.1 0.0.0.0 area 0 ! ip forward-protocol nd ! ! no ip http server no ip http secure-server ip nat pool flatpool 172.16.1.89 172.16.1.89 prefix-length 30 ip nat inside source list 1 pool flatpool overload ip route 0.0.0.0 0.0.0.0 172.16.1.254 ! ! ! access-list 1 permit 10.0.0.0 0.255.255.255 ! control-plane ! banner exec ` ************************************************************************** * IOSv is strictly limited to use for evaluation, demonstration and IOS * * education. IOSv is provided as-is and is not supported by Cisco's * * Technical Advisory Center. Any use or disclosure, in whole or in part, * * of the IOSv Software or Documentation to any third party for any * * purposes is expressly prohibited except as otherwise authorized by * * Cisco in writing. * **************************************************************************` banner incoming ` ************************************************************************** * IOSv is strictly limited to use for evaluation, demonstration and IOS * * education. IOSv is provided as-is and is not supported by Cisco's * * Technical Advisory Center. Any use or disclosure, in whole or in part, * * of the IOSv Software or Documentation to any third party for any * * purposes is expressly prohibited except as otherwise authorized by * * Cisco in writing. * **************************************************************************` banner login ` ************************************************************************** * IOSv is strictly limited to use for evaluation, demonstration and IOS * * education. IOSv is provided as-is and is not supported by Cisco's * * Technical Advisory Center. Any use or disclosure, in whole or in part, * * of the IOSv Software or Documentation to any third party for any * * purposes is expressly prohibited except as otherwise authorized by * * Cisco in writing. * **************************************************************************` ! line con 0 password cisco line aux 0 line vty 0 4 exec-timeout 720 0 password cisco login transport input telnet ssh ! no scheduler allocate ! end ! IOSvL2 Config generated on 2015-09-03 21:26 ! by autonetkit_0.18.1 ! version 15.2 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption service compress-config no service config enable password cisco ip classless ip subnet-zero no ip domain lookup ! line vty 0 4 transport input ssh telnet exec-timeout 720 0 password cisco login ! line con 0 password cisco ! hostname iosvl2-1 ! boot-start-marker boot-end-marker ! ! ! no aaa new-model ! ! ! ! ! ! ! ! ip cef no ipv6 cef ! ! spanning-tree mode pvst spanning-tree extend system-id ! vlan internal allocation policy ascending ! ! ! ! vrf definition Mgmt-intf ! address-family ipv4 exit-address-family ! address-family ipv6 exit-address-family ! ! ! ! ! interface Loopback0 description Loopback ! interface GigabitEthernet0/0 description Mapped to Vlan1 for management ! Configured on launch switchport mode access no shutdown ! interface GigabitEthernet0/1 description to iosvl2-3 switchport trunk encapsulation dot1q switchport mode trunk no shutdown ! interface GigabitEthernet0/2 description to server-1 switchport access vlan 2 switchport mode access no shutdown ! interface Vlan1 description OOB Management ! Configured on launch vrf forwarding Mgmt-intf no ip address ! ! ip forward-protocol nd ! no ip http server no ip http secure-server ! ! ! ! ! ! control-plane ! ! ! end ! IOSvL2 Config generated on 2015-09-03 21:26 ! by autonetkit_0.18.1 ! version 15.2 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption service compress-config no service config enable password cisco ip classless ip subnet-zero no ip domain lookup ! line vty 0 4 transport input ssh telnet exec-timeout 720 0 password cisco login ! line con 0 password cisco ! hostname iosvl2-2 ! boot-start-marker boot-end-marker ! ! ! no aaa new-model ! ! ! ! ! ! ! ! ip cef no ipv6 cef ! ! spanning-tree mode pvst spanning-tree extend system-id ! vlan internal allocation policy ascending ! ! ! ! vrf definition Mgmt-intf ! address-family ipv4 exit-address-family ! address-family ipv6 exit-address-family ! ! ! ! ! interface Loopback0 description Loopback ! interface GigabitEthernet0/0 description Mapped to Vlan1 for management ! Configured on launch switchport mode access no shutdown ! interface GigabitEthernet0/1 description to iosvl2-3 switchport trunk encapsulation dot1q switchport mode trunk no shutdown ! interface GigabitEthernet0/2 description to server-2 switchport access vlan 2 switchport mode access no shutdown ! interface Vlan1 description OOB Management ! Configured on launch vrf forwarding Mgmt-intf no ip address ! ! ip forward-protocol nd ! no ip http server no ip http secure-server ! ! ! ! ! ! control-plane ! ! ! end ! IOSvL2 Config generated on 2015-09-03 21:26 ! by autonetkit_0.18.1 ! version 15.2 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption service compress-config no service config enable password cisco ip classless ip subnet-zero no ip domain lookup ! line vty 0 4 transport input ssh telnet exec-timeout 720 0 password cisco login ! line con 0 password cisco ! hostname iosvl2-3 ! boot-start-marker boot-end-marker ! ! ! no aaa new-model ! ! ! ! ! ! ! ! ip cef no ipv6 cef ! ! spanning-tree mode pvst spanning-tree extend system-id ! vlan internal allocation policy ascending ! ! ! ! vrf definition Mgmt-intf ! address-family ipv4 exit-address-family ! address-family ipv6 exit-address-family ! ! ! ! ! interface Loopback0 description Loopback ! interface GigabitEthernet0/0 description Mapped to Vlan1 for management ! Configured on launch switchport mode access no shutdown ! interface GigabitEthernet0/1 description to iosvl2-2 switchport trunk encapsulation dot1q switchport mode trunk no shutdown ! interface GigabitEthernet0/2 description to iosvl2-1 switchport trunk encapsulation dot1q switchport mode trunk no shutdown ! interface GigabitEthernet0/3 description to iosv-1 switchport access vlan 2 switchport mode access no shutdown ! interface Vlan1 description OOB Management ! Configured on launch vrf forwarding Mgmt-intf no ip address ! ! ip forward-protocol nd ! no ip http server no ip http secure-server ! ! ! ! ! ! control-plane ! ! ! end #cloud-config bootcmd: - ln -s -t /etc/rc.d /etc/rc.local hostname: server-1 manage_etc_hosts: true runcmd: - start ttyS0 - systemctl start getty@ttyS0.service - systemctl start rc-local - sed -i '/^\s*PasswordAuthentication\s\+no/d' /etc/ssh/sshd_config - echo "UseDNS no" >> /etc/ssh/sshd_config - service ssh restart - service sshd restart users: - default - gecos: User configured by VIRL Configuration Engine 0.18.9 lock-passwd: false name: cisco plain-text-passwd: cisco shell: /bin/bash ssh-authorized-keys: - VIRL-USER-SSH-PUBLIC-KEY sudo: ALL=(ALL) ALL write_files: - path: /etc/init/ttyS0.conf owner: root:root content: | # ttyS0 - getty # This service maintains a getty on ttyS0 from the point the system is # started until it is shut down again. start on stopped rc or RUNLEVEL=[12345] stop on runlevel [!12345] respawn exec /sbin/getty -L 115200 ttyS0 vt102 permissions: '0644' - path: /etc/systemd/system/dhclient@.service content: | [Unit] Description=Run dhclient on %i interface After=network.target [Service] Type=oneshot ExecStart=/sbin/dhclient %i -pf /var/run/dhclient.%i.pid -lf /var/lib/dhclient/dhclient.%i.lease RemainAfterExit=yes owner: root:root permissions: '0644' - path: /etc/rc.local owner: root:root permissions: '0755' content: |- #!/bin/sh -e ifconfig eth1 up 10.0.0.2 netmask 255.255.0.0 route add -host 192.168.0.1 gw 10.0.0.1 dev eth1 route add -net 10.0.0.0/16 gw 10.0.0.1 dev eth1 exit 0 #cloud-config bootcmd: - ln -s -t /etc/rc.d /etc/rc.local hostname: server-2 manage_etc_hosts: true runcmd: - start ttyS0 - systemctl start getty@ttyS0.service - systemctl start rc-local - sed -i '/^\s*PasswordAuthentication\s\+no/d' /etc/ssh/sshd_config - echo "UseDNS no" >> /etc/ssh/sshd_config - service ssh restart - service sshd restart users: - default - gecos: User configured by VIRL Configuration Engine 0.18.9 lock-passwd: false name: cisco plain-text-passwd: cisco shell: /bin/bash ssh-authorized-keys: - VIRL-USER-SSH-PUBLIC-KEY sudo: ALL=(ALL) ALL write_files: - path: /etc/init/ttyS0.conf owner: root:root content: | # ttyS0 - getty # This service maintains a getty on ttyS0 from the point the system is # started until it is shut down again. start on stopped rc or RUNLEVEL=[12345] stop on runlevel [!12345] respawn exec /sbin/getty -L 115200 ttyS0 vt102 permissions: '0644' - path: /etc/systemd/system/dhclient@.service content: | [Unit] Description=Run dhclient on %i interface After=network.target [Service] Type=oneshot ExecStart=/sbin/dhclient %i -pf /var/run/dhclient.%i.pid -lf /var/lib/dhclient/dhclient.%i.lease RemainAfterExit=yes owner: root:root permissions: '0644' - path: /etc/rc.local owner: root:root permissions: '0755' content: |- #!/bin/sh -e ifconfig eth1 up 10.0.0.3 netmask 255.255.0.0 route add -host 192.168.0.1 gw 10.0.0.1 dev eth1 route add -net 10.0.0.0/16 gw 10.0.0.1 dev eth1 exit 0